Home > Fireplace & Refractory Products > Plaster & Render

Heat Resistant PLASTER


Our Price: £31.99
Inc VAT: £38.39
Earn 38 Points with this purchase

Heat Resistant Plaster by Vicas

High temperature smooth finish render. Protection up to 650°C (1200°F) Vitcas® Heat Resistant Plaster is a replacement material for gypsum plaster where the temperatures are too high for gypsum plaster to stay on the wall.
Do not treat as Gypsum Plaster. For use around the opening of cassette fireplaces (sometimes called hole in the wall fires) and adjacent to wood burning stoves and range cookers where the area of the wall is subjected to intense heat.
The plaster should be used in the areas subject to intense heat approx 3m (10 ft) around the fire opening. Maximum recommended thickness of the material is 5mm. Remove all traces of old render and plaster on the wall or part of wall to be treated. Re-render using VITCAS®FIREPLACE RENDER prior to applying Vitcas® Heat Resistant Plaster. It is important to ensure that the Vitcas®Fireplace Render is fully dried prior to applying Vitcas®Heat Resistant Plaster. The Vitcas®Fireplace Render should be left to dry for at least 3 days in temperatures above 18 degrees centigrade and for longer if moisture is still present as apparent by the colour of the material. If possible apply heat after day one ie light the fire or use another type of heater. Prepare the area by coating with undiluted Vitcas®PVA Adhesive Sealer.

VITCAS Heat Resistant Plaster & High Temperature Plasterboard
If you need to apply the plaster onto a board then we ONLY recommend using VITCAS®HIGH TEMPERATURE PLASTERBOARD which is designed for this purpose.

For plastering the boards with Vitcas Plaster, it should be fixed with the rough reverse face and the board sealed with neat PVA before starting to plaster when the PVA becomes tacky.

The material should be mixed with cold tap water to a 
usable consistency with a plaster mixer / drill attachment. There should be no traces of ordinary Portland cement or gypsum plaster on the tools or in the mixing buckets. It is best to mix the plaster in the bucket in which it is supplied.

Take care not to mix the material too wet.
As a guide the amount of water required is approximately 200 ml per kilo. A thickness of approx 3-6mm should be applied. It is important that the plaster is applied evenly i.e. no 
feather edges. The surface finish must be obtained during flotation with the trowel. The material cannot be sanded when dry. Due to the surface being dense and non-porous when dry it is not suitable for finish skimming. Any minor cracks can be repaired using VITCAS® HEAT RESISTANT FILLER. When dry the finished surface forms a very hard heat resistant surface that can be painted over as required. VITCAS® HEAT RESISTANT PLASTER must be allowed to air dry for at least 3 days before lighting fire.

Coverage: 20kg bucket will cover approximately 2m2 (20 ft2) at a thickness of 6mm (1/4”)
Keep any unused material dry and store in a cool dry place away from children and pets. Warning: Do not breathe the dust. In case of contact with skin and eyes rinse immediately with plenty of water and seek medical advice. After contact with skin, wash with water Wear suitable gloves and eye face protection. Keep out of reach of children.

The information given is based on our experience and reports from customers. There are many factors outside our control and knowledge, especially the method and conditions of application which affect the use and performance of our products and for which reason no warranty is given, express or implied. Users should make their own tests to determine the applicability of such information or the suitability of any products for their own particular purposes

Customer Reviews
Write an online review and share your thoughts with other shoppers!

©Copyrights 2015 FIREPLUG. All Rights Reserved.